CISS Ink wire blockage

Main problems:

1) When you use injector to draw out ink for many times, most drawn out is air.

2) You can't find one colour entirely (most is black colour)

Settlement:

First take procedures as "pump air from ink cartridge", if you find there is no ink flowing

into the injector after hard pump, you can be sure the ink wire is blocked, and please do

according following steps:

・Cartridge nozzle is blocked.

Seal all the plugs of external ink tank, turn it over, use injector to draw out the ink from

cartridge nozzle, then it can be dredged.

・Joint elbow is blocked.

Pull out the joint elbow from the upside of cartridges, check if it is blocked. If yes, use

clean water to clean it, then use injector to dredge it.

・Ink wire blocked.

If you are sure cartridge nozzle and joint elbow is dredged, use injector to draw ink from

the cartridge nozzle, if ink surface at external tank will not lower, you can be sure ink wire

is blocked. You can first check if there is foreign body at the two sides of ink wire, if yes,

try to dredge it. If other parts of the wire blocked, you can only contact with our local

distributor.

・Air filter at external tank is blocked.

Please check air filter, and clean it.

Note: If you have any other problems with this Continuous Ink System, please contact info@mir-aus.com.